Valdern TOWEL RAIL ELECTRIC HEATING ELEMENT (150W / 250W / 300W / 400W / 600W) WATT FOR BATHROOM HEATED TOWEL RAILS AND RADIATORS WARMERS/CHROME CAP / 1.2M LONG CABLE (600 Watt)

  • Stock : In Stock
  • Product Code: B0816TZ5DY
£32.00£28.99

IP64 Rated Electric Towel Rail Heating Element , Available in 150W - 250W -300W - 400W and 600W

Length 350mm ( 150W, 250W, 300W, 400W) , Length 450mm (600W) Diameter 12.5mm , Cable Length 1200mm, 1/2" BSP Standard Thread , Chrome Cap

CE, TUV Certified, 2 Years Warranty, Thermocut out 70C Degrees

Please select suitable one according to your towel rail dimensions.

The element must only be fitted at the bottom of the radiator.

Show more

Product details

Brand ‎Valdern
Colour‎Chrome Cap / White Cable
Size:600 Watt

This electric heating element is designed for installation in selected domestic decorative and towel radiators. It is not necessarily suitable for use with other products. The element can be used as electric only or in a centrally heated system ( Dual Fuel ) to provide heating of the towel rail when the central heating system switched off (e.g during the summer). Protection device fitted inside the heater prevents over heating of the towel rail. The element should not be tested out of water. The element must only be fitted at the bottom of the radiator.The element must be fitted to the radiator before mounting the radiator on the wall. These heaters are suitable for use as stand alone electrically heated or with all Open Vented Central Heating Systems. If they are used with sealed central heating systems or combination boiler systems, it is essential that you establish that there is adequate allowance for expansion. The work must be done to the standard in the Wiring Regulations and you should consider having work checked by a competent electrician to ensure it is safe. Thermocut out point 70C Degrees.

Customer questions and answers

  • Hi, is this compatible with any electric towel rail, is the thread a standard size?
    Valdern elements have a 1/2 inch BSP thread which is standard for this type of fitting.
  • Does it run on 12V?
    220V - 240V
  • Is the element flexible? (only have about 4" clearance between base and floor) - If not, can you get a flexible version?
    No, it’s a solid tube. To fit it you must remove the radiator from wall, turn it upside down, remove old unit and fit new unit before returning radiator to wall again. No one makes flexible immersion elements- DO NOT try to bend any element to fit!
  • does this include the t-piece to allow dual fuel running?
    This listing is for heating element only , you can use the link below to buy a dual fuel kit that comes with element + Chrome T piece + Blanking Plug https://www.amazon.co.uk/dp/B08155D1QF/ref=cm_sw_r_cp_awdb_t1_b1faFbXYRJPQY

Related products