STAIGO TOUCH SENSOR CONTROL BOX REPLACEMENT LIFT

Technical Parameters:

Rated voltage: 29V

Rated current: 1.8A

Length:about 243cm

Operation guide:

1. Turn on the motor

Touch the button to open the motor (A), the motor keeps extending until it stops at the farthest point. During the touch, if the touch is stopped, the motor will also stop extending.

2. Take back the motor

Touch the button to retract the motor (the other button), and the motor will continue to retract until it stops at the farthest point. During the touch, if the touch is stopped, the motor will also stop the retracting action.

Note: The above operation guide is applicable to the clockwise running of the motor. When the motor counterclockwise running, (another Button) TURN ON, (Button A) TAKE BACK.

Reminding:

1. When installing this control components, you must confirm the applicable power supply model, and check the line connection according to our connection diagram, otherwise it may cause damage to some parts due to improper connection.

2. When the product fails, please contact our after-sales service for your rights, and do not disassemble it for repair without authorization.

3. When not in use for a long time, please disconnect the main power supply.

Installation Tips:

1. The leather hole is 6mm, and the product is inserted into the leather hole.

2. Install the gasket anti-loosing glue and tighten the terminal wire screws.

Package Include:

Control box x 1

Touch controller x 2

Mounting screws x 2