DIY FLOOR LAMP KIT TALL CYLINDER 200MM X 740MM HIGH

Our kit makes you a 200mm diametre floor lamp that stands 740mm high from the covering of your choice. Design to match your upholstery, curtains, wallpaper or any room theme. Floor lamp Assembled Size - 200mm Diametre x 740mm high How to make them Easy to use, laminate your covering to the self adhesive panel and follow the step by step instructions. If you would like to view the instructions see pictures. What size will my covering need to be? - Your covering needs to be 750mm x 670mm to fit over the self adhesive panel supplied.

What's in the box 1 x Floor lamp ring 200mm, epoxy coated 1 x Floor lamp ring 200mm, epoxy coated with utility fitting and built in stand 3 x White plastic feet covers 1 x Self adhesive panel (White liner) size 728mm x 648mm includes 14mm kiss cut 1 x 3mtr roll self adhesive tape 1 x Rolled Edge tool for finishing What type of lamp holder will this floor lamp fit The utility frame included in your kit will fit the standard bayonet cap (BC) lamp holder. It can also be used with Edison Screw (E27) lamp holders, simply remove the converter plug in the centre of the utility fitting. Electrical Fittings Electrical fittings which comprise of lamp holder, plug and switched cable ARE NOT INCLUDED and need to be purchased separately for UK or European plug and socket types. Where can I purchase the Lamp holder, Plug and Switched Cable? They are sold on Amazon.The units we sell are fully tested in compliance with EU legislation for health and safety. How do they fit? Simply connect the lamp holder to the utility ring, fit your bulb, then plug straight into your electrical socket and switch on using the online switch. Bulb Advice- Maximum Wattage 40watt - We recommend the use of low energy bulbs with your floor lamp. They use less energy and are cool to the touch.